建立了&nbsp;高功率 激光辐 照下光 学表面 存在划 痕且 残存

郭文华; 陶冶; 张蓉竹

doi:10.11884/HPLPB202032.190303

建立了高功率激光辐照下光学表面存在划痕且残存

doi: 10.11884/HPLPB202032.190303

郭文华^1,,
陶冶^2, ,,
张蓉竹¹

详细信息

作者简介:
郭文华(1994—)，男，硕士研究生，主要从事激光与材料相互作用方面的研究工作；domissi@163.com

通讯作者:
陶　冶(1984—)，男，四川大学机械工程学院副教授，主要从事精密测量与传感方面的研究工作； yetao@scu.edu.cn

中图分类号: TN24
计量
- 文章访问数: 506
- HTML全文浏览量: 238
- PDF下载量: 2
- 被引次数: 0
出版历程
- 收稿日期: 2019-08-16
- 修回日期: 2019-11-04
- 发布日期: 2020-03-17

Effect of residual polishing particles on thermal damage characteristics of materials in surface scratches

Wenhua Guo^1
,,
Ye Tao^{2
, ,},
Rongzhu Zhang¹

摘要

摘要: 建立了高功率激光辐照下光学表面存在划痕且残存抛光颗粒时的热损伤分析模型，对这种复杂缺陷条件下的光学材料热损伤性能进行了研究。利用有限差分法计算了不同尺度抛光颗粒处于划痕中不同位置时光学材料表面的光场调制和温度场的分布。根据表面温度分布，得到了对应条件下光学材料的热损伤阈值变化规律。结果表明：除了抛光颗粒半径对材料损伤阈值存在影响外，当抛光颗粒位于划痕宽度方向不同位置时，材料的热损伤阈值也会有比较明显的变化；当位于划痕中心时，抛光颗粒对材料光场调制最强，更容易造成材料的熔化损伤。
- 抛光颗粒 /
- 有限差分法 /
- 热损伤阈值 /
- 光场调制
Abstract: A thermal damage analysis model of scratches and residual polishing particles on the optical surface is established. The thermal damage properties of optical materials under such complex defects are studied. The finite difference method was used to calculate the light field modulation and temperature field distribution of the optical material surface at different positions of the polished particles at different scales. According to the surface temperature distribution, the thermal damage threshold of the optical material under the corresponding conditions is achieved. The results show that in addition to the influence of the polishing particle radius on the material damage threshold, when the polishing particles are located at different positions in the scratch width direction, the thermal damage threshold of the material will also change significantly. Among them, the polishing particles in the center of the scratch have the strongest modulation on the light field, and are more likely to cause melting damage of the material.
- polished particles /
- FDTD /
- thermal damage threshold /
- light field modulation

HTML全文

图 1 同时存在划痕与抛光颗粒分析模型示意图

Figure 1. Schematic diagram of the analysis model of scratches and polished particle

下载: 全尺寸图片幻灯片

图 2 抛光颗粒在划痕宽度方向上不同位置对材料表面光场分布的影响

Figure 2. Effect of polishing particles on the light field distribution of the material surface at different positions in the width direction of the scratch

下载: 全尺寸图片幻灯片

图 3 划痕宽度不同位置处抛光颗粒对光场调制(a)及热损伤阈值(b)的影响

Figure 3. Effect of polishing particles on the light field modulation (a) and thermal damage threshold (b) at different locations of the scratch width

下载: 全尺寸图片幻灯片

图 4 划痕长度不同位置处抛光颗粒对光场调制(a)及热损伤阈值(b)的影响

Figure 4. Effect of polishing particles on the light field modulation (a) and thermal damage threshold (b) at different locations of the scratch length

下载: 全尺寸图片幻灯片

图 5 不同半径的抛光颗粒对光场调制(a)及热损伤阈值(b)的影响

Figure 5. Effect of polishing particles with different radii on light field modulation (a) and thermal damage threshold (b)

下载: 全尺寸图片幻灯片

参考文献(11)

[1]	Walker T W, Guenther A H, Nielsen P E. Pulsed laser-induced damage to thin-film optical coatings—Part I: Experimental[J]. IEEE Journal of Quantum Electronics, 1981, 17(10): 2041-2052. doi: 10.1109/JQE.1981.1070662
[2]	项震, 聂传继, 葛剑虹, 等. 光学元件亚表面缺陷结构的蚀刻消除[J]. 强激光与粒子束, 2007, 19(3):373-376. (Xiang Zhen, Nie Chuanji, Ge Jianhong, et al. Eliminating of subsurface damage structure[J]. High Power Laser and Particle Beams, 2007, 19(3): 373-376
[3]	蒋勇. 熔石英光学元件表面损伤修复的理论和实验研究[D]. 成都: 电子科技大学, 2012: 34-42. Jiang Yong. Theoretical and experimental studies on surface damage repair of fused silica optical components. Chengdu: University of Electronic Science and Technology of China, 2012: 34-42
[4]	江修娥, 王斌, 刘剑, 等. 激光脉宽对光学薄膜元件热损伤的影响[J]. 激光与红外, 2017, 47(1):32-37. (Jiang Xiue, Wang Bin, Liu Jian, et al. Effect of pulse durations on laser thermal damage of optical thin films[J]. Laser & Infrared, 2017, 47(1): 32-37 doi: 10.3969/j.issn.1001-5078.2017.01.006
[5]	Bloembergen N. Role of cracks, pores, and absorbing inclusions on laser induced damage threshold at surfaces of transparent dielectrics[J]. Applied Optics, 1973, 12(4): 661-664. doi: 10.1364/AO.12.000661
[6]	花金荣, 蒋晓东, 祖小涛, 等. 熔石英亚表面横向划痕调制作用的3维模拟[J]. 强激光与粒子束, 2010, 22(7):1441-1444. (Hua Jinrong, Jiang Xiaodong, Zu Xiaotao, et al. Three dimensional numerical simulation of modulation by transverse crack on fused silica subsurface[J]. High Power Laser and Particle Beams, 2010, 22(7): 1441-1444
[7]	章春来, 王治国, 向霞, 等. 熔石英后表面坑点型划痕对光场调制的近场模拟[J]. 物理学报, 2012, 61:114210. (Zhang Chunlai, Wang Zhiguo, Xiang Xia, et al. Simulation of field intensification induced by pit-shaped crack on fused silica rear-surface[J]. Physica Sinica, 2012, 61: 114210 doi: 10.7498/aps.61.114210
[8]	Xie Yanxin, Qi Lei, Liu Yali, et al. Influence of surface cracks on laser-induced thermal damage characteristics of optical material[J]. Optik, 2019, 184: 220-226. doi: 10.1016/j.ijleo.2019.03.059
[9]	尤科伟, 张艳丽, 张雪洁, 等. 光学元件表面缺陷相对位置分布对近场光束质量的影响[J]. 中国激光, 2015, 42:0308004. (You Kewei, Zhang Yanli, Zhang Xuejie, et al. Influence of relative position of optical component surface defects on near field beam quality[J]. Chinese J Lasers, 2015, 42: 0308004
[10]	苏倩倩, 张国文, 陶华, 等. 非线性介质表面缺陷对激光光场的调制[J]. 强激光与粒子束, 2012, 24(11):2585-2590. (Su Qianqian, Zhang Guowen, Tao Hua, et al. Modulation of nonlinear medium with surface defects on intensity properties of laser[J]. High Power Laser and Particle Beams, 2012, 24(11): 2585-2590
[11]	Carslaw H S, Jaeger J C. Conduction of heat in solids[M]. Oxford: Oxford University Press, 1986.